Skoda Octavia II 2004 Workshop Manual page 23

1.1.2 Summary of components - propshaft, Octavia II as of 06/2007
1 - Angle gearbox
2 - Screw
❑ 3 pieces
❑ M10 x 30
❑ 60 Nm
3 - Propshaft
❑ Removing and installing
⇒ "1.3 Removing and in‐
stalling propshaft", page
26
❑ when installing and re‐
moving do not damage
the centering bushing
and gasket ring in the
middle of the flange
❑ Fitting position: the in‐
termediate bearing Pos.
5 is located in the direc‐
tion of travel behind the
monoblock joint -arrow-
4 - Screw
❑ 3 pieces
❑ M10 x 45
❑ 60 Nm
5 - Flexible disk/oscillation
damper
❑ Assignment ⇒ Electron‐
ic Catalogue of Original
Parts
❑ Removing and installing
⇒ "1.6 Removing and in‐
stalling the rear flexible
disk", page 46
6 - Screw
❑ Replace after disassembly
❑ 50 Nm + 90°
7 - Intermediate bearing
❑ align free of stress
❑ replace propshaft if damaged
8 - Heat shield
9 - Screw
❑ 25 Nm
10 - Rear final drive
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
19
1. Propshaft