Skoda Octavia II 2004 Workshop Manual page 107

7 - Sealing ring
❑ in housing for four-wheel drive clutch
❑ coat with high-performance oil for four-wheel drive clutch before inserting
❑ Replace after disassembly
8 - Sealing ring
❑ for pressure sensor
❑ coat with high-performance oil for four-wheel drive clutch before inserting
❑ Replace after disassembly
9 - Pressure sensor
❑ can be re-used when replacing the control unit
10 - Disc spring
❑ Fitting position ⇒ page 103
Fitting position of the disc spring
• The marking -arrow- on the curved side of the disc spring -2-
points in the fitting position upwards and towards the pressure
sensor -1-.
6.2.2 Summary of components - generation IV four-wheel drive clutch control unit
- J492- , final drive 0BR, Octavia II, Superb II, Yeti, up to 10/2013
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
103
6. Four-wheel drive clutch