Skoda Octavia II 2004 Workshop Manual page 39

– Screw the pendulum support with new screws -arrow B- and
-arrow C- onto the gearbox ⇒ Engine; Rep. gr. 10
Note
As of gearbox production date 28/05/2007, threaded inserts
♦
are located in the bolt-holes for the pendulum support (e.g.
"Heli Coil").
Identifying feature: shoulder at the first thread -arrow-. These
♦
threaded inserts can be installed with Thread Repair Kit , e.g.
-VAS 6024- .
Pay attention to the corresponding fixing screws and the tight‐
♦
ening torque for the pendulum support ⇒ Engine; Rep. gr.
10 .
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Note
If droning noises occur while driving, the following must be
♦
observed.
Unscrew the propshaft with the flexible disk from the flange of
♦
the four-wheel drive clutch and screw on again offset by one
hole.
♦ If the droning noises can still be heard, the propshaft must be
screwed on once again offset to a hole.
Tightening torques
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
♦ ⇒ "1.1.2 Summary of components - propshaft, Octavia II as of
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
06/2007", page 19
1.3.3 Removing and installing propshaft, Su‐
perb II
Special tools and workshop equipment required
♦ Engine/gearbox jack , e.g. -V.A.G 1383A-
♦ Thread repair set , e. g. -VAS 6024-
♦ Counterholder - T10172-
♦ Adapter - T10172/5-
Removing
• Work on the propshaft should be carried out on a two-pillar lift
platform.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
35
1. Propshaft