Skoda Octavia II 2004 Workshop Manual page 134

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Propshaft and rear final drive - Edition 10.2018
– Unscrew propshaft with flexible disk and oscillation damper
from rear final drive -arrows-.
When loosening and tightening, counterhold the propshaft on the
rear final drive.
– With the aid of a 2nd mechanic, press the engine/gearbox unit
forwards in -direction of arrow- and place a suitable wooden
wedge -A- (around 50 mm thick) between the assembly carrier
-B- and gearbox -C-.
– While doing so, remove the propshaft from the flange at the
four-wheel drive clutch (centering stud) on the rear final drive.
• Do not tilt propshaft when removing, pull off horizontally from
centering stud of final drive towards the rear. The gasket ring
in the centering bush -arrow- must not be damaged, otherwise
the propshaft must be replaced.
130
Rep. gr.39 - Final drive - rear differential
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.