Skoda Octavia II 2004 Workshop Manual page 129

– Unscrew guide bars - T10093- and tighten screws -arrows- to
specified tightening torque.
– Install propshaft at rear final drive
⇒ "1.3 Removing and installing propshaft", page 26
– Tighten the pendulum support with new screws -B- and -C- on
the gearbox. Tightening torques ⇒ Engine; Rep. gr. 10 .
– Align intermediate bearing free of stress and tighten. Tighten‐
ing torque ⇒ "1.4 Repairing propshaft", page 43
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Check the oil level in the four-wheel drive clutch, top up with
oil if necessary
⇒ "6.4 Checking oil level in the four-wheel drive clutch",
page 106 .
Tightening torques
♦ Propshaft to rear final drive
⇒ "1.1 Summary of components - propeller shaft", page 16
♦ Four-wheel drive clutch
⇒ "6.1 Summary of components - four-wheel drive clutch",
page 92
♦ Oil inspection and oil drain plugs
⇒ "5.1 Installation location overview - drain plug and check
screw", page 90
6.8.3 Removing and installing V generation
four-wheel drive clutch, final drive 0BR,
Yeti from 11/2013
Special tools and workshop equipment required
♦ Guide bars - T10093-
♦ counterholder - T10172- with adapters - T10172/5-
♦ Used oil collector and extractor - V.A.G 1782-
In Yeti vehicles with rear final drive 0BR, generation IV four-wheel
drive clutch was installed up to production date 10/2013. From
production date 11/2013, the generation V four-wheel drive clutch
is installed. Assignment ⇒ Electronic Catalogue of Original Parts
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Superb II 2008 ➤ , Superb II 20 ...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Propshaft and rear final drive - Edition 10.2018
.
.
125
6. Four-wheel drive clutch