Sending E-Mail Using The Ladder Program; E-Mail Send Processing Using The Ladder Program - Panasonic FP2 ET-LAN Technical Manual

11.8 Sending E-mail Using the Ladder Program

In the ladder send e-mail function, e-mails can be sent by the instruction using the ladder program.
Using the ladder program of the CPU unit, the e-mail send processing is executed by turning ON the e-
mail send request signal in the handshake area which is allocated in the ET-LAN unit.
E-mail message to be sent can be specified by entering the necessary data in the ladder e-mail send
setting area using the ladder program.
- Setting items for the ladder send e-mail
Setting item
Recipient e-mail
address
Ladder send
e-mail Selection of e-mail message to be
sent
Selection of a signature
Reference: Control Configurator ET "Operational Guide Book" (ARCT1F341E)

11.8.1 E-mail Send Processing Using the Ladder Program

Handshake using the shared memory
-
A CPU unit requests the ET-LAN unit for sending an e-mail and checks if the e-mail is successfully sent
to the specified destination by means of a shared memory handshake.
Reference: <Chapter 4 Confirming the Design Contents>
E-mail send complete signal area (Bank: 0)
-
Address Description
bit 2 E-mail send complete signal
362H
bit 3 E-mail send error signal
E-mail send request signal area (Bank: 0)
-
Address Description
36AH bit 2 E-mail send request signal
Description
To The destination addresses based on the
No. of the Address Book which is
Cc
registered using the setup tool
(Configurator ET) are specified. Up to 32
Bcc
addresses can be specified each for "To",
"Cc", and "Bcc".
Using the ladder program, the No. of the
message, which is registered with the setup
tool (Configurator ET), is specified.
Whether the signature is attached to a
message or not is selected. A signature is
registered using the setup tool
(Configurator ET).
11-15