Codes For Ip Configuration - Aastra OpenCom 100 Mounting And Commissioning User Manual

Configuration
1. The "Administrator" user logs-in with the administration password.
2. They open the Configurator.
A message shows which user is currently configuring the system.
3. The administrator clicks on the Take over config rights button.
The other user can make no further modifications of the configuration.

7.2.9 Codes for IP Configuration

The IP configuration of the OpenCom 100 is performed on the Web console in the
Configurator, in the Network: LAN menu.
In the event that the IP configuration of the OpenCom 100 has to be changed and
access via the Web console is not possible, you can also use a code digit procedure
to change these basic settings. Entry can be made from an analogue telephone, an
ISDN telephone and from system telephones.
Set IP Address
H *182 Z
Z * Z
(www) (xxx)
Set NET Mask
H *183 Z
Z * Z
(www) (xxx)
Example
H*182
Enter:
0000*192*168*99*254#
If required, initiate a system restart with the following procedure:
Trigger Restart
H * 1 8 5 Z
Use the PIN you entered in the dialogue box for initial access. The factory setting is
"0000".
*
(system PIN)
* Z * Z
(yyy)
*
(system PIN)
* Z * Z
(yyy)
#
(system PIN)
Configuring the OpenCom 100
#
(zzz)
#
(zzz)
85