Safety Precautions - Aastra OpenCom 100 Mounting And Commissioning User Manual

Installation
3.2

Safety Precautions

The CE symbol on the product confirms that it meets the technical guidelines on
user safety and electromagnetic compatibility valid at the time of approval.
Please note:
DANGER!
The OpenCom 100 may only be plugged into mains sockets with a protective
earth conductor. Mount the OpenCom 100 only close to easily accessible sockets.
Only use the original plug-in power supply: No. 4512699 (TR25240-E-01A13 type)
for an OpenCom 131 and for the basic module of an OpenCom 130.
The housing cover may only be opened by authorised personnel. Unauthorised
opening of the housing cover and improper repair may damage the
OpenCom 100 and invalidate the warrantee.
CAUTION!
Only terminals that deliver safety extra-low voltage (SELV) may be connected to
the OpenCom 100. Proper use of authorised terminals meets this requirement.
Only terminals meeting the technical requirements may be connected to the ana-
logue ports. For details, refer to the section entitled a/b Ports starting on page 51.
Use a shielded Ethernet cable (STP cable, Shielded Twisted Pair cable) to connect
the OpenCom 100 to a Local Area Network (LAN).
Installation and maintenance should only be performed by
specially trained personnel. Always remove the power plug
and the plug-in power supply from the mains socket before
opening the housing cover and/or connecting devices to the
OpenCom 100 ports.
This device contains hazardous voltages. To make the sys-
tem powerless, remove the power plug and the plug-in
power supply from the socket.
Static charges can damage the OpenCom 100.
Make sure you discharge yourself and your tools
before and while installing electrical and
electronic components of the OpenCom 100.
Safety Precautions
25