Table of Contents
Advertisement
Installation
Assigning a route
In order to allow the analogue lines of the M100-AT4 Interface Card to be used for
outgoing calls, the bundle needs to be assigned to a route:
1. Open the Telephony: Trunks: Route menu.
On the status page, the list of previously configured routes is displayed.
2. Click on the New button. Alternatively, click one of the route entries to assign
the bundle to an existing route.
3. Select the bundle you have configured from the Choice list and enter a route
name in the Name field (only if you are configuring a new route).
4. Click on the Apply button.
The newly configured or changed route is displayed in the list on the status
page.
Configuring the a/b ports
In the following step, you have to configure each of the M100-AT4 Interface Card
ports:
1. Open the Telephony: Ports: a/b menu.
The four M100-AT4 Interface Card ports are displayed for the selected slot.
2. Click on the desired a/b port.
3. Select the configured bundle from the Bundle list. Enter the desired access
number in the Port Ph. No. field.
4. Click on the Apply button.
Configuring the call distribution
In order to allow incoming calls to be signalled to the designated terminals, the
access numbers configured for the M100-AT4 Interface Card a/b ports must be
assigned to internal call numbers:
1. Open the Telephony: Call Distribution: Incoming menu.
36
Installing Interface Cards
Advertisement
Table of Contents
