Configuration - Aastra OpenCom 100 Mounting And Commissioning User Manual

S Connector Module
2M
7. Reconnect the OpenCom 130 / 150 to the power supply.
8. Configure the S
(refer to Configuration starting on page 76). Check the level 1 status with ref-
erence to the LEDs on the module. None of the LEDs are illuminated before the
S module has been configured.
2M
LED Display
LED
1 (green)
2 (green)
3 (yellow)
4 (red)
9. Pull out the mains plug of the OpenCom 130 / 150 again and close the housing.
10.Reconnect the OpenCom 130 / 150 to the power supply.
5.2

Configuration

The menu item S
2M
installation of the S
item. Further information on this can be found in the online help.
module in the Configurator of the OpenCom 130 / 150
2M
appears in the Configurator, menu Telephony: Ports after
module. Configure the port in the input mask of this menu
2M
Meaning
Synchronous (= ok)
Blue alarm
Remote alarm or out of sync
(yellow alarm)
Loss of signal (red alarm)
Configuration
71