Aastra OpenCom 100 Mounting And Commissioning User Manual page 86

Configuration
Remote Configuration On (Log-on with Temporary Password)
H * 1 9 * Z
Remote Configuration Off
H # 1 9 #
Please note:
The customer service centre/authorised dealer can log into the OpenCom 100
communications system as an administrator:
■
User name: "Administrator"
■
Password: [administrator password]
Using remote configuration, all OpenCom 100 settings with the exception of the
system PIN can be edited or updated. New software versions of the OpenCom 100
and the software for the connected system terminals and base stations can also be
installed (see the System: Firmware menu in the Configurator).
For security reasons, settings in the Configurator, Network menu should only be
edited on site to avoid malfunctions or failures in the customer's LAN (e.g. due to IP
address conflicts). Refer to the chapter entitled Configuration Examples starting on
page 90, where interaction between the OpenCom 100 and a LAN is explained.
Forced Logoff of Another User by the Administrator
If the user "Administrator" logs in and another user with administration rights is
already logged in, then the administrator can forcibly log the other user off in
order to configure. This functionality, for example can be used, when configuring
remotely, when a user has forgotten to log out.
In order to forcibly log a user off:
84
* Z
(system PIN)
The system PIN is preset to "0000" and it is absolutely imper-
ative that the system administrator changes it to prevent un-
desirable remote maintenance.
Note: If you do not wish to let the customer service centre/
authorised dealer know the administrator password, you can
define a temporary password for remote configuration with
at least five digits.
Configuring the OpenCom 100
(temporary password)
#