Aastra OpenCom 100 Mounting And Commissioning User Manual page 12

Features
■
You can use an additional insertable memory card (CompactFlash) to operate
further programme packages, viz. the OpenVoice and OpenAttendant digital
voice memory and voice information systems.
■
The special interface card M100-AT4 enables connecting analogue exchange
lines. Additional information can be found in the user manual "M100-AT4
Interface Card".
■
The additional S
OpenCom 130 / 150 on a primary rate access.
Telephony
The OpenCom 100 communications system is designed to be connected to an
ISDN basic access using the DSS1 protocol. System access (point-to-point) and
multi-terminal access (point-to-multipoint) are both supported. The two forms of
access can be configured in parallel.
For this purpose
■
the OpenCom 131 includes two S
switched between internal/external),
■
the OpenCom 130 basic module includes two S
one that can be switched between internal/external),
■
the OpenCom 130 expansion module with additional interface cards provides
up to eight further S
overview of the available cards can be found under Interface Cards starting on
page 43,
■
the OpenCom 150 with interface cards provides up to 12 S
between internal/external). An overview of all possible interface card combina-
tions can be found under OpenCom 150 (5 Slots) starting on page 46.
The OpenCom 100 complies with the regulations for telecommunications
equipment. The DSS1 protocol is implemented.
The firmware of the OpenCom 100 is designed for configuring up to 300 users.
You can connect the following devices to the OpenCom 100:
10
connector module allows you to operate an
2M
0
ports (switchable between internal/external). An
0
ports (one external one and one that can be
ports (one external one and
0
ports (switchable
0