Aastra OpenCom 100 Mounting And Commissioning User Manual page 112

Hide thumbs Also See for OpenCom 100:
Table of Contents

Advertisement

Voice over IP (VoIP)
Quality Levels for Voice Transmission with VoIP
Level
Voice Comprehensibility
3
Satisfactory
4
Limited
> 4
Unacceptable
When a call is set up, the terminals involved negotiate the voice-data compression
("codec") that will be used. This is the first factor that determines the achievable
quality level:
G.711 A-Law or µ-Law (Level 1, uncompressed): The audio data of a PCM
channel (64 kbit/s) is adopted one-to-one. Every VoIP terminal must support
this codec. This codec can not be used with an ISDN data connection.
G.729A (Level 2): Reduction to approximately 8 kbit/s.
G.723.1 6.3 (Level 3): Reduction to 6.3 kbit/s.
G.723.1 5.3 (Level 3): Reduction to 5.3 kbit/s.
Unfavourable packet length selection may reduce voice quality. The duration of
the recording and not the data packet's byte count is relevant in making this
selection:
Duration <= 30 ms: optimal transmission
Duration 40 - 60 ms: one quality-level depreciation
Duration > 60 ms: two quality-levels depreciation
The achievable voice quality also depends on the packet propagation delay and
the packet loss between the terminals involved. These parameters can be deter-
mined using the "ping" programme.
110
Note: Measurements made with "ping" are round-trip prop-
agation delays. Divide the maximum value displayed by two.
Comparable to
GSM
Defective GSM
No Connection
Fundamentals

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OpenCom 100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents