Configuration; Bundles; Routes - Aastra OpenCom 100 Mounting And Commissioning User Manual

PBX Networking
12.3

Configuration

The possible configurations described below can be set up in the Web console
using the Telephony: Trunks menu.

12.3.1 Bundles

A bundle is a group of lines of the same type and direction. A line can only be
assigned to one bundle.
Network
PBX 1
operator
A
C
B D
PBX 2
Example of a PBX network with bundles
In the above example, the following bundles are configured for PBX 1:
■
Two S lines in a multi-terminal configuration to the network operator which
0
are assigned to the "A" bundle.
■
Two S point-to-point connections to PBX 2 which are assigned to the "C"
0
bundle.
■
One S point-to-point connection to PBX 3 which is assigned to the "E" bundle.
0

12.3.2 Routes

A route is a group of bundles enabling a connection in one direction. If the first
bundle of a route is fully utilized, the next bundle is seized ("bundle overflow").
One bundle can also be used for different routes.
Note: Q.SIG-IP cannot be operated using a connection with
NAT. For a Q.SIG-IP connection, a branch connection or an-
other VPN connection is required.
PBX 3
E
Bundle
Trunk line
Point-to-point
connection
Note: A line or a bundle cannot be seized directly. It is al-
ways performed indirectly via a route.
Configuration
159