Setting Of Unit; How To Set The Unit System - Fuji Electric FLR-3 Instruction Manual

4.8.1. How to set the unit system

Description
 Measurement unit can be selected from metric or inch system.
 Metric system (factory set)
Length ······································ mm
Flow velocity ······························ m/s
Flow rate ··································· L/s, L/min, L/h, L/d, kL/d, ML/d, m
Total unit ··································· mL, L, m
Kinematic viscosity coefficient ······· E
<Note> When setting, stop status should be set at total mode. (See Section 4.9.2.)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Change the unit system from inch system to metric system.
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
▼
▼
▼
Press the
ESC
mode.
INF-TN3FLR-E

4.8. Setting of unit

BBL/d, kBBL/d, MBBL/d
3 3
, km , Mm
-6 2
m /s
Description
key for 3 times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key once to blink the cursor.
ENT
key once to display "METRIC".
key once to register.
ENT
――― METRIC has been registered. ―――
key once and key twice to return to the measurement
ESC
3 3 3
/s, m /min, m /h, m
3
, mBBL, BBL, kBBL
3 3 3
/d, km /d, Mm /d, BBL/s, BBL/min, BBL/h,
Display
MEASURE SETUP
SYSTEM UNIT
SYSTEM UNIT
SYSTEM UNIT
SYSTEM UNIT
 COMPLETE 
↓
SYSTEM UNIT
0.000 m/s
0.000 m3/h
INCH
INCH
METRIC
METRIC
- 27 -