How To Validate The Output At The Minus Direction Action - Fuji Electric FLR-3 Instruction Manual

4.10.5.6. How to validate the output at the minus direction action

Description
 Select a contact output as DO1 and/or DO2 when the flow is in reverse direction.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the DO1 output to "-:FLOW DIRECTION".
(example) Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
* Press the
Press the
ENT
▼
Press the
▼
2nd line.
Press the
ENT
▼
▼
――― "-:FLOW DIRECTION" has been registered. ―――
▼
▼
Press the
ENT
▼
Press the
ENT
▼
* To select normally on, press the
▼
▼
▼
Press the
ESC
the measurement mode.
- 58 -
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 6 times to display "DO1 OUT".
key again to display "DO2 OUT".
key once to blink the cursor.
ENT
key for 9 times to display "-:FLOW DIRECTION" on the
key once to register "-:FLOW DIRECTION".
ENT
key once to display "CONTACT ACTION".
ENT
key once to register "ACTIVE ON"(normally off).
ENT
key.
――― "ACTIVE ON" has been registered. ―――
key twice and then press the
ESC
OUTPUT SETUP
ZERO ADJUSTMENT
DO1 OUT
DO1 OUT
DO1 OUT
DO1 OUT
STATUS OUT
CONTACT ACTION
CONTACT ACTION
STATUS OUT
key for 3 times to enter
Display
SET ZERO
NOT USED
NOT USED
-:FLOW DIRECTION
 COMPLETE 
↓
CONTACT ACTION
ACTIVE ON
 COMPLETE 
↓
CONTACT ACTION
0.000 %
0.000 m3
INF-TN3FLR-E