How To Validate The Output At The Minus; Direction Action - Fuji Electric Time Delta-C FSV-2 Instruction Manual

4.10.5.6. How to validate the output at the minus direction action
Description
 Select a contact output as DO1 and/or DO2 when the flow is in reverse direction.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set the DO1 output to "-:FLOW DIRECTION".
(example) Also, set the contact to "ACTIVE ON".
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
* Press the
Press the
ENT
▼
Press the
▼
2nd line.
Press the
ENT
▼
▼
――― "-:FLOW DIRECTION" has been registered. ―――
▼
▼
Press the
ENT
▼
Press the
ENT
▼
* To select normally on, press the
▼
▼
▼
Press the
ESC
the measurement mode.
Description
key twice to display "OUTPUT SETUP".
key once to display "ZERO ADJUSTMENT".
ENT
key for 6 times to display "DO1 OUT".
key again to display "DO2 OUT".
key once to blink the cursor.
ENT
key for 9 times to display "-:FLOW DIRECTION" on the
key once to register "-:FLOW DIRECTION".
ENT
key once to display "CONTACT ACTION".
ENT
key once to register "ACTIVE ON"(normally off).
ENT
――― "ACTIVE ON" has been registered. ―――
key twice and then press the
ESC
key.
key for 3 times to enter
-61-
Display
OUTPUT SETUP
ZERO ADJUSTMENT
SET ZERO
DO1 OUT
NOT USED
DO1 OUT
NOT USED
DO1 OUT
-:FLOW DIRECTION
DO1 OUT
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
CONTACT ACTION
ACTIVE ON
CONTACT ACTION
 COMPLETE 
↓
STATUS OUT
CONTACT ACTION
0.000 %
0.000 m3