How To Set The Total Unit - Fuji Electric Time Delta-C FSV-2 Instruction Manual

4.8.3. How to set the total unit

Description
 Select the unit of total volume.
 Metric system
Total unit ········ mL, L, m
<Note> First, set the unit system (metric) according to Section 4.8.1.
When setting, stop status should be set at total mode. (See Section 4.9.2.)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
Operation Set a flow total unit to "L".
(example)
Key operation
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
Press the
▼
Press the
ENT
▼
▼
▼
▼
Press the
ESC
measurement mode.
3 3 3
(factory set), km , Mm , mBBL, BBL, kBBL
Description
key for ３ times to display "MEASURE SETUP".
key once to display "SYSTEM UNIT".
ENT
key once to display "TOTAL UNIT".
key once to blink the cursor.
ENT
key twice to display "L".
key once to register.
ENT
――― "L" has been registered. ―――
key once and the key twice to return to the
ESC
-32-
Display
MEASURE SETUP
SYSTEM UNIT
TOTAL UNIT
TOTAL UNIT
TOTAL UNIT
TOTAL UNIT
 COMPLETE 
↓
TOTAL UNIT
0.000 L
0.000 L/min
METRIC
m3
m3
L
L