Oven Bay; Oven Door; Oven Components; Oven Lamps - Stratasys Fortus 360mc User Manual

Oven Bay

Oven Door

The Oven Assembly (also called the Oven Bay) includes the oven door and
everything that you see through the front door glass. The bay is where parts are
built. The oven door uses a continuous solenoid. The Unlock Hood/Door
command will release the solenoid allowing you to open the door.
1.
From the Main Menu select
2.
Select
Note: This command is only available while the system is
paused or in an idle state. You do not have access to this
command while the gantry is moving.
3.
If the temperature is high, a warning screen may appear. Press ENTER again
to unlock the door.
Note: Once any door is unlocked and/or opened, system
operation cannot be resumed. Additionally, a manual move
command cannot be sent until all doors are closed. When all
doors are closed, the solenoids reactivate and you can resume
operation.

Oven Components

Gloves: Oven lights are hot! Do not touch without wearing approved
safety gloves.

Oven Lamps

There are two incandescent oven lamps mounted in the two front upper corners
of the oven. The lamps are rated at 240 volts and 40 watts. There is a lamp (light)
switch on the keypad, which you can use to manually turn the light ON or OFF.
(Figure
Build Job..
>Operator Control..
Modeler Status..
Maintenance..
and press ENTER
Unlock Door
>Unlock Door <E>
Load/Unload Matl..
Change Tips/Matl..
3-9)
Operator Control
| *Tips: Model T16
| * Support T16
| Calibrate..
| Temp Control..
| Move Head/Stage..
3-13
and press ENTER