Parameters Available In The Setup Group - YASKAWA V1000 Quick Start Manual

4.2 The Drive and Programming Modes
◆

Parameters Available in the Setup Group

Setup Mode (StUP)
■
Parameters used for this drive are classified into A to U. To simplify the drive setup,
frequently used parameters are selected and input into Setup Mode.
1.
To set a parameter, the Setup Mode must be displayed first.
2.
If the parameter setting is insufficient, set the parameters in the Parameter Setting
Mode.
Note: When parameter A1-02 (Control Method Selection) is changed, some parameter set values are
also changed automatically. Execute the A1-02 setting before Auto-tuning.
Table 4.2 lists parameters available in the Setup Group.
Note: This manual also explains other parameters not visible in the Setup Group (A1-06 = 0). Use the
"Par" menu in the Programming mode to access parameters not listed in the Setup Group. The
Setup Group parameters are shown in
Note: Display parameters depend on A1-06.
Parameter
A1-02 Control Method Selection
b1-01 Frequency Reference Selection 1
b1-02 Run Command Selection 1
b1-03 Stop Method Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
C6-01 Duty Selection
C6-02 Carrier Frequency Selection
d1-01 Frequency Reference 1
d1-02 Frequency Reference 2
d1-03 Frequency Reference 3
d1-04 Frequency Reference 4
d1-17 Jog Frequency Reference
58
Table 4.2
Refer to Application Presets on page
Table 4.2 Setup Group Parameters
Name
YASKAWA ELECTRIC TOEP C710606 14A YASKAWA AC Drive - V1000 Quick Start Guide
Parameter
E1-01 Input Voltage Reference
E1-03 V/f Pattern Selection
E1-04 Maximum Output Frequency (FMAX)
E1-05 Maximum Voltage (VMAX)
E1-06 Base Frequency (FA)
E1-09 Minimum Output Frequency (FMIN)
E1-13 Base Voltage (VBASE)
E2-01 Motor Rated Current
E2-04 Number of Motor Poles
E2-11 Motor Rate Capacity
H4-02 Terminal FM Gain Setting
L1-01 Motor Protection Function Selection
L3-04 Stall Prevention Selection during Deceleration
64.
Name