YASKAWA V1000 Quick Start Manual page 60

4.3 Start-up Flowcharts
Figure 4.2
? b1-01/02 for frequency reference and run command source selection
? H1-
,H2-
? d1-
for multi-speed references if used
? C1-
and C2-
? C6-01 for heavy/normal duty mode selection
? L3-04 if braking options are used
0: V/f control
To
Flowchart A-
1
Run the motor without load, check the rotation direction and operation. Verify, external signal
Couple the load or machine to the motor. Run the machine and check it operates as desired
Fine tune parameters. Adjust application settings (PID, ...) if necessary
60
START
Install and wire the drive as explained in Chapters 1, 2 and 3
Apply main power on to the drive.
Adhere to safety messages concerning application of power
Application Presets
A1-06 used ?
Set the control mode in parameter A1-02.
For information about the control modes refer to Section 4.5
Set the basic parameters:
,H3- ,H4- ,H6-
for accel./decel. and S-curve time settings
Control Mode
A1-02 =
Flowchart A-
commands to the drive work as desired
Check the machine operation and verify parameter settings.
Drive is ready to run the application
Figure 4.2 Basic Start-Up and Motor Tuning
YASKAWA ELECTRIC TOEP C710606 14A YASKAWA AC Drive - V1000 Quick Start Guide
No
for I/O terminal setting
5: Open Loop Vector for PM motors
2: Open Loop
To
Vector control
2
Yes
Refer to section
4.4 Application
Macros
To
Flowchart A-
3
From Flowchart A-1, A-2, or A-3
TO