YASKAWA V1000 Quick Start Manual page 129

H2-
Function
Setting
1C Motor 2 Selection
1E Restart Enabled
1F Overload Alarm OL1
20 OH Pre alarm
22 Mechanical Weakening (N.O.)
30 During Torque Limit
37 During Frequency Output
38 Drive Enable
39 Watt Hour Pulse Output
3C Drive Mode
3D Speed Search
3E PID Feedback Loss
3F PID Feedback Fault
4A KEB Operation
4B Short-Circuit Brake
4C During Fast-stop
4D OH Pre-alarm Time Limit
H2 Parameter Functions
100 to
Reversed Output Switching of 0
14D
to 92
No. Name
Use H3 parameters to set the multi-function analog input terminals.
H3-01 Terminal A1 Signal Level Selection
H3-02 Terminal A1 Function Selection
H3-03 Terminal A1 Gain Setting
H3-04 Terminal A1 Bias Setting
YASKAWA ELECTRIC TOEP C710606 14A YASKAWA AC Drive - V1000 Quick Start Guide
H2 Multi-Function Digital Output Settings
Closed: Motor 2 is selected by a digital input (H1-
Closed: An automatic restart is performed
Closed: OL1 is at 90% of its trip point or greater.
Closed: Heatsink temperature exceeds the parameter L8-02 value.
Closed: Mechanical Weakening detected.
Closed: When the torque limit has been reached.
Closed: Frequency is output
Open: Operation stopped, Baseblock, DC Injection Braking, or Initial
Excitation is being performed.
Closed: Multi-function input closes (H1-
Output units are determined by H2-06, outputs 200 ms pulse for each
incremented kWh count.
Closed: Local
Open: Remote
Closed: Speed search is being executed.
Closed: PID Feedback Loss.
Closed: PID Feedback Fault.
Closed: KEB is being performed.
Closed: Short-Circuit Braking is active.
Closed: Fast-stop command is entered
Closed: OH Pre-alarm time limit is passed.
Reverse the output switching of the multi-function output functions. Set
the last two digits of 1
function.
H3: Analog Inputs
0: 0 to +10 V (lower limit)
1: 0 to +10 V (no lower limit)
Sets the function of terminal A1.
Sets the level of the input value selected in H3-02 when 10V is input
at terminal A1.
Sets the level of the input value selected in H3-02 when 0V is input
at terminal A1.
7.1 Parameter Table
Description
= 6A)
to reverse the output signal of that specific
Description
= 16)
7
129