YASKAWA V1000 Quick Start Manual page 137

No. Name
Speed Feedback Detection Control
n8-45
Gain
Pull-In Current Compensation
n8-47
Time Constant
n8-48 Pull-In Current
n8-49 Load Current
n8-51 Acceleration Pull-In Current
Voltage Error compensation time
n8-54
constant
n8-55 Load Inertia
n8-62 Output voltage limit
Drive Mode Unit Monitor
o1-01
Selection
User Monitor Selection After
o1-02
Power Up
o1-03 Digital Operator Display Selection
Frequency Reference Setting and
o1-10
User-Set Display
Frequency Reference Setting /
o1-11
Decimal Display
Use o2 parameters to configure LED digital operator key functions.
LOCAL/REMOTE Key Function
o2-01
Selection
o2-02 STOP Key Function Selection
o2-03 User Parameter Default Value
o2-04 Drive/kVA Selection
Frequency Reference Setting
o2-05
Method Selection
Operation Selection when Digital
o2-06
Operator is Disconnected
YASKAWA ELECTRIC TOEP C710606 14A YASKAWA AC Drive - V1000 Quick Start Guide
n8: Permanent Magnet (PM) Motor Control
Use n8 parameters to control the PM motor control.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
o1: Display Settings
Use o1 parameters to configure the digital operator display.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
0: Hz
1: % (100% = E1-04)
2: r/min (enter the number of motor poles into E2-04/E4-04/E5-04)
3: User defined by parameters o1-10 and o1-11
Refer to V1000 Technical Manual for details.
o2: Multi-Function Selections
Refer to V1000 Technical Manual for details.
Enables/Disables the operator panel STOP key when the drive is
operated form external sources (not operator).
0: Disabled.
1: Enabled
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
0: Data/Enter key must be pressed to enter a frequency reference.
1: Data/Enter key is not required. The frequency reference is adjusted
by the "up" and "down" arrow keys.
0: The drive will continue operation
1: The drive will trigger a fault (OPR) and the motor will coast to stop
7.1 Parameter Table
Description
7
137