YASKAWA V1000 Quick Start Manual page 131

No. Name
Multi-Function Analog Output
H4-02
Terminal AM Gain
Multi-Function Analog Output
H4-03
Terminal AM Gain
Use H5 Parameters to connect the drive to a MEMOBUS/Modbus network.
H5-01 Drive Node Address
H5-02 Communication Speed Selection
H5-03 Communication Parity Selection
Stopping Method After
H5-04
Communication Error
Communication Fault Detection
H5-05
Selection
H5-06 Drive Transmit Wait Time
H5-07 RTS Control Selection
H5-09 CE Detection Time
Unit Selection for MEMOBUS/
H5-10
Modbus Register 0025H
Communications ENTER
H5-11
Function Selection
H5-12 Run Command Method Selection
Pulse Train Input Terminal RP
H6-01
Function Selection
YASKAWA ELECTRIC TOEP C710606 14A YASKAWA AC Drive - V1000 Quick Start Guide
Sets terminal AM output level when selected monitor is at 100%.
Refer to V1000 Technical Manual for details.
H5: MEMOBUS/Modbus Communications
Selects drive station node number (address) for MEMOBUS/Modbus
terminals R+, R-, S+, S-. Cycle power for the setting to take effect.
0: 1200 bps
1: 2400 bps
2: 4800 bps
3: 9600 bps
4: 19200 bps
5: 38400 bps
6: 57600 bps
7: 76800 bps
8: 115200 bps
0: No parity
1: Even parity
2: Odd parity
0: Ramp to stop
1: Coast to stop
2: Fast-stop
3: Alarm only
0: Disabled
1: Enabled - If communication is lost for more than two seconds, a CE
fault will occur.
Set the wait time between receiving and sending data.
0: Disabled - RTS is always on.
1: Enabled - RTS turns on only when sending.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
Refer to V1000 Technical Manual for details.
H6: Pulse Train Input/Output
Use H6 parameters to configure Pulse Train I/O operation.
0: Frequency reference
1: PID feedback value
2: PID setpoint value
3: Simple PG V/f control mode (can be set only when using motor 1 in
the V/f control mode)
7.1 Parameter Table
Description
7
131