Operation With Pc - HBM DMP41 Interface Description

Documentation overview
How to work with this manual
6
Various guides are available to help you:
S The table of contents at the beginning of the manual provide an initial
overview.
S The header shows you which chapter or sub‐chapter you are currently
reading.
S Example:
S The footer displays the name of the manual (Operating with computer or
terminal, Operating manual, etc.)
S The page numbers are coupled with capital letters according to the
chapter designations. Each chapter starts with Page 1.
S If you are looking for individual commands, it is best to refer to the
command overview in Appendix IV or Appendix V.
S The keyword index contains an index register to help you orientate
yourself rapidly in the manual.
1.1.1

Operation with PC

This manual explains the operation of your HBM device with a computer.
S You can implement all device settings by sending an appropriate
command sequence from the computer. Automation of repetitive
measurement sequences is possible with a computer and the
corresponding programs.
In order to match up the signals output from or required by the various
devices (computer, plotter, printer, measuring device, etc.), the devices
must be connected together via interfaces.
Interfaces are standardized so that devices from various manufacturers can
be used.
The DMP device can be operated via the following standardized interfaces:
S Ethernet interface
S USB port for RS232
Administrator rights are required for all measurement‐relevant settings
(see also Page 28)
A03474_04_E00_00 HBM: public
DMP41