HBM DMP41 Interface Description page 35

SRB
DMP41
The interface is set to 4800 baud, no parity,
2 stop bits.
Select Response Behavior
Select interface acknowledgement behavior
Syntax: SRB p1(x)
Parameter:
p1 Switch acknowledgment output on/off
0 Switch acknowledgment output off
1 Switch acknowledgment output on
2 Command; Response is returned
Effect: There are two command modes:
a.
Output commands (e.g. MSV?) that are identified by a
question mark generate output data independently of the
interface acknowledgement behavior selection. The output
of this data cannot be suppressed with this command.
b.
Setting commands (e.g. SRB) generate acknowledgement
data (0 or ?). The output of this data can be switched on/off
with this command.
Example 1: SRB?(x)
Device ->
Example 2: SRB?;2(x)
Device <-
or
SRB2(x) Device ->
SRB2;0(x) Device <-
The responses are activated after the DMP41 is switched
on.
Response:
A03474_04_E00_00 HBM: public
Command set of the HBM interpreter
Communication
35