Chapter 8 Event And Alarm; Set Motion Detection; Normal Mode - HIKVISION DS-2TXS2628-10P/QA/GLT/CH36S80 User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
This part introduces the configuration of events. The device takes certain response to triggered
alarm. Certain events may not be supported by certain device models.

8.1 Set Motion Detection

It helps to detect the moving objects in the detection region and trigger the linkage actions.
Steps
1. Go to Configuration → Event → Basic Event → Motion Detection .
2. Select the channel No.
3. Check Enable Motion Detection.
4. Optional: Highlight to display the moving object in the image in green.
1) Check Enable Dynamic Analysis for Motion.
2) Go to Configuration → Local .
3) Set Rules to Enable.
5. Select Configuration Mode, and set rule region and rule parameters.
- For the information about normal mode, see Normal Mode .
- For the information about expert mode, see Expert Mode .
6. Set the arming schedule and linkage methods. For the information about arming schedule
settings, see Set Arming Schedule . For the information about linkage methods, see Linkage
Method Settings .
7. Click Save.

8.1.1 Normal Mode

You can set motion detection parameters according to the device default parameters.
Steps
1. Select normal mode in Configuration.
2. Set the sensitivity of normal mode. The higher the value of sensitivity is, the more sensitive the
motion detection is. If the sensitivity is set to 0, motion detection and dynamic analysis do not
take effect.
3. Set Detection Target. Human and vehicle are available. If the detection target is not selected, all
the detected targets will be reported, including the human and vehicle.
4. Click Draw Area. Click and drag the mouse on the live video, and then release the mouse to
finish drawing one area.
Stop Drawing Stop drawing one area.
Clear All
5. Optional: You can set the parameters of multiple areas by repeating the above steps.

Chapter 8 Event and Alarm

Clear all the areas.
59