About Rfid Module Settings; Supported Tag Type (Iso); Supported Tag Type (Gen 1); Supported Tag Type (Gen 2) - Intermec IF5 User Manual

About RFID Module Settings

IF5 Fixed Reader User's Manual
Chapter 3 — Developing and Using RFID Applications
3 Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes,
and then click Save Changes and Reboot. For help, see
"Saving Configuration Changes" on page 22.
Note: If you make changes to RFID settings, you need to
reboot the IF5 to activate the changes.
This section explains the module settings. Most settings have BRI
attribute equivalents. For more information, see the Basic Reader
Interface Programmer's Reference Manual (P/N 937-000-xxx).

Supported Tag Type (ISO)

Sets the type of ISO tag for RFID operations. See the next table
for more information. Default is None.
This setting is equivalent to the TAGTYPE BRI attribute.
ISO Tag Type Descriptions
Tag Type
ISO6B/G1
ISO6B/G2
Phillips v1.19
None

Supported Tag Type (Gen 1)

Enables or disables Gen 1 tag support for RFID operations.
Choose EPC Class 1 Gen 1 to enable Gen 1 support, or None
(default) to disable Gen 1 support.

Supported Tag Type (Gen 2)

Enables or disables Gen 2 tag support for RFID operations.
Choose EPC Class 1 Gen 2 (default) to enable Gen 2 support, or
None to disable Gen 2 support.

Dense Reader Mode

Check this check box to enable dense reader mode, which is only
supported by EPC Class 1 Gen 2 tags. When dense reader mode
is enabled, these tags respond with Miller Sub carrier encoded
data instead of FM0 encoded data.
Description
ISO6B Generation 1
ISO6B Generation 2
Phillips v1.19
Disables ISO tag operations
75