Intermec IV7 Accessory Manual

Vehicle-mount reader data cable kit

Hide thumbs Also See for IV7:

See also: Instruction Manual , User Manual

Use this cable to connect the IV7 Vehicle-Mount Reader to:

• the serial port on a PC.

• general purpose input/output (GPIO) devices such as motion sensors.

These instructions explain how to assemble the data cable and include

guidelines for installing the cable on the vehicle.

Note: Before you assemble the data cable, you need to choose a

mounting location for the IV7 on the vehicle. For more

information, see the IV7 Vehicle-Mount Reader Instructions (P/N

075280-xxx for the standard IV7, or P/N 943-100-xxx for the

ALBR IV7).

This kit (P/N 203-776-001) includes these items:

• Data cable with 20-pin connector, 12 ft (P/N 236-086-001)

• Heatshrink tubing, 1/8 in x 3 ft

• Twenty-four crimp connectors (P/N 809-083-027)

• Four 2K, 1-watt resistors

Required Tools

To assemble the data cable, you need these tools:

• Wire cutters and stripper

• Crimping tool

• Heat gun

Vehicle-Mount Reader Data Cable Kit Instructions

IV7

Table of Contents

Do you have a question about the IV7 and is the answer not in the manual?

Page 1 Vehicle-Mount Reader Data Cable Kit Instructions Use this cable to connect the IV7 Vehicle-Mount Reader to: • the serial port on a PC. • general purpose input/output (GPIO) devices such as motion sensors. These instructions explain how to assemble the data cable and include guidelines for installing the cable on the vehicle.
Page 2 Assembling the Data Cable Once you have determined where the IV7 will be mounted on the vehicle, you can begin assembling the data cable. To assemble the data cable 1 Strip the sheath from the unterminated end of the cable as needed. If necessary, be sure to leave enough room for strain relief.
Page 3 After you assemble the data cable, install it on the vehicle as described in the IV7 instructions. For more information on safely installing the cable, see the next section. Description TXD from IV7 RXD to IV7 Ground CTS from IV7...
Page 4 Cable Safety Guidelines In addition to the data cable, the IV7 requires power and antenna cables to connect it to your vehicle-mounted RFID system. As you install the cables, follow these safety guidelines: • Make sure that the cable routing does not interfere with other equipment or vehicle controls.