Interface Module - Intermec EasyCoder 301 Service Manual

Bar code label printer

Hide thumbs Also See for EasyCoder 301:

Table of Contents

3.2

Interface Module

Connector J2

CPU Board

WARNING!

Before removing the electrics

cover, turn off the printer and

disconnect the power cord. High volt-

age wires and circuits inside.

Intermec EasyCoder 301 – Service Manual Ed. 3

Description

The Interface Module consists of a simple printed circuit board on

which a push button switch, a multi-colour LED and a cable are

fitted. The Interface Module is fitted in rails at the front part of the

centreline wall and its cable is connected to J2 on the CPU board.

Replacement

In case of a defect Interface Module, do not try to repair it but replace

the entire module.

• Turn off the power to the printer and remove the power cord.

• Open the front cover.

• Remove the electrics cover (see chapter 2.3).

• Remove the CPU board (see chapter 11.2).

• Insert a narrow screwdriver or similar into the hole in the centre

of the Interface Module pcb and pry it out of the rails.

• Disconnect the connector from J2.

• Fit the replacement Interface Module in reverse order.

Chapter 3

Front and Operator Interface

LED Control Lamp

Push Button Switch

Table of Contents