Configuring Settings For Your Network; Configuring Ethernet Settings - Intermec IF5 User Manual

Chapter 2 — Configuring Network Settings

Configuring Settings for Your Network

Configuring Ethernet Settings

30
This chapter assumes that you are using the IF5 web browser
interface to configure network settings on the IF5. For help, see
"Using the Web Browser Interface" on page 19.
You can also configure network settings by:
• using a communications program to access the IF5. For help,
see "Using a Communications Program" on page 10.
• using Intermec Settings from within the Intermec
SmartSystems™ Console. For help, see
SmartSystems Console" on page 103.
• using a Simple Management Network Protocol (SNMP)
station to access the IF5. For help, see
Network Management Protocol (SNMP)" on page 98.
• using the Wavelink Avalanche client management system to
access the IF5. For help, see
page 101.
This section explains how to configure these wired Ethernet
settings using the web browser interface:
• DHCP mode
• (If DHCP is enabled) DHCP server name, user class, and
vendor class
• IP address
• IP subnet mask
• IP router (gateway)
• Link speed
Note: If you are using a DHCP server, you may not need to
configure Ethernet settings. For more information, contact your
network administrator.
For help with enabling IPv6 and configuring settings, see
"Enabling IPv6" on page 33.
"Using the Intermec
"Using Simple
"Using Wavelink Avalanche" on
IF5 Fixed Reader User's Manual