Configuring 802.1X Client Settings - Intermec IF5 User Manual

Chapter 2 — Configuring Network Settings

Configuring 802.1x Client Settings

60
WPA2-802.1x Parameter Descriptions
Parameter
Minimum Multicast
Encryption Type
Authentication
Method
For Dynamic WEP and 802.1x security, you may need to
configure 802.1x client settings. For help, see the next table.
802.1x Client Parameter Descriptions
Parameter
Allow TLS
Allow TTLS
(MSCHAPv2)
Allow PEAP
Allow LEAP
Description
Choose a data encryption method for non-
unicast transmission/reception:
CCMP (RSN): Use Counter Mode - CBC
MAC Protocol for multicast/group keying.
TKIP (RSN) (Temporal Key Integrity
Protocol): Choose this option for multicast/
group keying.
WEP (TSN, non-WiFi) (Wired Equivalent
Privacy): Choose this option to use WEP
keying for group/multicast keys.
Specifies whether encryption will be used as
part of the authentication. Choose Network
EAP to require encryption, or choose Open
System to require no encryption.
Description
Enables/disables Transport Layer Security
(TLS) authentication.
If you enable TLS with WPA or 802.1x
security, you must have a unique client
certificate on the IF5 and a trusted root
certificate authority (CA) certificate. For more
information, see the next section, "About
Certificates."
Enables/disables Tunneled Transport Layer
Security (TTLS) authentication.
Enables/disables Protected Extensible
Authentication Protocol (PEAP)
authentication.
Enables/disables Lightweight Extensible
Authentication Protocol (LEAP)
authentication.
IF5 Fixed Reader User's Manual