Using The Web Browser Interface - Intermec IF5 User Manual

Using the Web Browser Interface

IF5 Fixed Reader User's Manual
8 Press the down arrow key to select Reboot and then press
Enter. The IF5 reboots. When the boot process is finished,
you see "Starting system" at the bottom of the HyperTerminal
screen.
9 Disconnect the null-modem cable and AC power cable from
the IF5.
The IF5 is now ready to be connected to your wireless network.
See "Connecting the IF5 to Your Network" on page 25.
After you have set the initial IP address, you can configure and
manage the IF5 remotely using the web browser interface. The
IF5 web browser interface has been tested using Internet Explorer
6.0. Using other browsers may provide unpredictable results.
To use the web browser interface, the IF5 must be connected to
your wired Ethernet or 802.11g wireless network.
If your session terminates abruptly or a new login screen appears,
someone else may have accessed the IF5. When using the web
browser interface, remember that your session terminates if you
do not use it for 15 minutes.
Note: If you access the Internet using a proxy server, add the IF5
IP address to your Exceptions list. The Exceptions list contains
the addresses that you do not want to use with a proxy server.
To use the IF5 web browser interface
1 Determine the IP address of the IF5. If a DHCP server
assigned the IP address, you need to get the IP address from
that server.
2 Start Internet Explorer.
3 In the Address field, enter the IP address, and press Enter.
The IF5 login screen appears.
Chapter 1 — Getting Started
19