Table of Contents
Advertisement
IF5 Fixed Reader User's Manual
Chapter 3 — Developing and Using RFID Applications
This setting is equivalent to the TIMEOUTMODE BRI
attribute, and is disabled by default.
To enable Timeout Configuration mode
1 Check the check box and then click Save Changes. The
screen refreshes. The Antenna Tries setting is replaced by
Antenna Timeout, and the ID Tries setting is replaced by ID
Timeout.
2 Specify the value (in ms) for the timeout in the entry fields
and then click Save Changes.
ID Tries
Sets the maximum number of times the reader executes the
identify algorithm before a response is returned to a Read or
Write command.
In practice, this is the number of times a tag ID attempt is made
for each antenna being used. Valid range is 1 to 254. Default is 3.
This setting is equivalent to the IDTRIES BRI attribute.
ID Timeout
Sets the ID timeout value (in ms) when Timeout Configuration
mode is enabled. The maximum value is 65000 (default is 100).
This setting is visible only if Timeout Configuration mode has
been enabled. For help, see "Timeout Configuration Mode" in
this section.
This setting is equivalent to the IDTIMEOUT BRI attribute.
Antenna Tries
Sets the maximum number of ID Tries that the reader executes
per antenna. Valid range is 1 (default) to 254.
This setting is equivalent to the ANTTRIES BRI attribute.
Antenna Timeout
Sets the antenna timeout value (in ms) when Timeout
Configuration mode is enabled. The maximum value is 65000
(default is 50). This setting is visible only if Timeout
Configuration mode has been enabled. For help, see "Timeout
Configuration Mode" in this section.
This setting is equivalent to the ANTTIMEOUT BRI attribute.
77
Advertisement
Table of Contents
Troubleshooting
