About Rfid Module Settings; Supported Tag Type; Supported Tag Type (Gen 2); Dense Reader Mode - Intermec IF30 User Manual

Chapter 3 — Creating and Using RFID Applications

About RFID Module Settings

44
This section explains the module settings. Most settings have BRI
attribute equivalents. For more information, see the Basic Reader
Interface Programmer's Reference Manual (P/N 937-000-xxx).

Supported Tag Type

Sets the type of tag for RFID operations. Certain performance
improvements can be realized if you choose the best setting for
your system. The more specific the selection, the better the
performance. See the next table for more information.
Tag Type Descriptions
Tag Type
Phillips v1.19
ISO6B/G1
ISO6B/G2
EPC Class 1 Gen 2 (default)
This setting is equivalent to the TAGTYPE BRI attribute.

Supported Tag Type (Gen 2)

Enables or disables Gen 2 tag support for RFID operations.
Choose EPC Class 1 Gen 2 (default) to enable Gen 2 support, or
None to disable Gen 2 support.

Dense Reader Mode

Check this check box to enable Dense Reader mode, which is
only supported by EPC Class 1 Gen 2 tags. When dense reader
mode is enabled, these tags respond with Miller Sub carrier
encoded data instead of FM0 encoded data.
This setting is equivalent to the DENSEREADERMODE BRI
attribute.

LBT Channel

(Supported only by 865 MHz readers) Sets the default transmit
channel (of the 10 ETSI 302-208 channels) when the Listen
Before Talk algorithm is enabled. Range is 1 to 10. Default
channel is 5. The setting is used only when the LBT Scan Enable
check box is not checked.
This setting is equivalent to the LBTCHANNEL BRI attribute.
Description
Phillips v1.19
ISO6B Generation 1
ISO6B Generation 2
EPCglobal Class 1 Gen 2
IF30 Fixed Reader User's Manual