Table of Contents
Advertisement
Item
Properties
Port OS: Use the drop-down menu to select the operating
system of the computer connected to the transmitter.
OS Language: Use the drop-down menu to select the
operating system language of the computer connected to the
transmitter.
Enable Multicast Video: Check this box to allow a broadcast of
the transmitter's video signal to be sent out to multiple
receivers.
Enable Multicast Audio: Check this box to allow a broadcast
of the transmitter's audio signal to be sent out to multiple
receivers.
EDID Mode Selection: EDID contains a display's basic
information and is used by the source device to utilize the best
resolution across different monitors. When Manual or Remix is
selected, the receiver's OSD will have a button allowing the
local EDID setting to be configured for the connection. Select
how you want the source device to acquire the display's EDID:
Enable Media
Select which type of media the transmitter can stream to
receivers: video, audio, USB, and RS-232.
RS232 Settings
Configure the serial device settings for the transmitter. The
default settings are:
Baud Rate: 9600
Parity: None
Data Bits: 8 bits
Stop bits: 1 bit
Flow Control: None
Manager
Set the IP address and Port number of the computer running
Address
the KVM over IP Matrix Manager. The default port number is
9110.
Default: EDID is set to the default ATEN configuration.
Auto: Checks the EDID of all connected displays and the
ATEN default EDID to use the best common resolution for all
displays.
Manual: Manually set the EDID configuration from the
Connections Page (see page 74).
Remix: Manually checks the EDID of all connected displays
and the ATEN default EDID to use the best common
resolution for all displays (see page 74).
Chapter 4. OSD Operation
Description
65
Advertisement
Table of Contents
