Table of Contents
Advertisement
The installation is similar to that of RCMDVI00BT / RCMDVI40BT /
RCMDVI50T Point-to-Point Installation on page 38, with the difference in
connecting the transmitter and the receiver to a local area TCP/IP network.
Refer to the diagrams on the following page and connect accordingly.
Repeat these steps for each transmitter and receiver you wish to install on the
network then power on the computer(s).
Note: 1. If you wish to use CCVSR and/or remote access with WinClient /
JavaClient, you will still need to connect the remote port of the
RCMDVI00BT / RCMDVI40BT / RCMDVI50T to an Office LAN.
2. It is highly recommended that the units are mounted on a system rack
or on a wall and avoid stacked setup to ensure proper ventilation
Chapter 2. Hardware Setup
43
Advertisement
Table of Contents
