Table of Contents
Advertisement
No.
Component
7
function switch
8
RS-232 port
9
USB ports (console)
10
SFP slot
11
DVI-I out
12
power jack
Use this switch to set the unit's mode to:
Auto: Shared (simultaneous) KVM control of the PC
/ workstation at the transmitter and receiver
console.*
RS-232 Config: The device is ready to be
configured via serial commands through the RS-232
port. When connected to a KVM over IP Access
Control Box (2XRT-0015G), users can enable /
disable control privileges of the connected
receivers.
Local: Only the local transmitter has KVM control of
the PC / workstation. The receiver's KVM access to
the PC / workstation is locked.
Note: In Auto mode, RS-232 and audio functions will
work on the receiver but not on the transmitter.
This RS-232 serial port is for connecting to a serial
terminal.
The unit's USB keyboard and USB mouse plug into
these ports.
The Gigabit Ethernet (GbE) optical fiber cable that
connects the unit to the LAN plugs in here.
The cable from the local DVI monitor plugs in here.
Connects a second power source for power
redundancy.
Chapter 1. Introduction
Description
13
Advertisement
Table of Contents
