Edid Command - ATEN RCMDVI00BT User Manual

EDID Command

Extended Display Identification Data (EDID) is a data that contains a display's
basic information and is used to communicate with the video source. The EDID
commands allow you to change the EDID setting of a transmitter. For more
information on configuring EDID settings, see Properties, page 60.
The formula for the EDID command is as follows:
Command + Address + Number + Control + [Enter]
1. For example, if you want to configure device (192.168.0.3) to use the
remix EDID mode, type the following:
edid a192.168.0.3 remix [Enter]
The following tables show the possible values for the EDID commands:
Command
edid
Address
Number
Control
auto
remix
default
manual
EDID command
a Address command
xx Address number
xx: receiver ID or IP address
Checks the EDID of all connected
displays and the ATEN default EDID to
use the best common resolution for all
displays.
Manually checks the EDID of all
connected displays and the ATEN default
EDID to use the best common resolution
for all displays (see EDID Mode,
page 76).
Implements ATEN's default EDID.
(default)
Manually set the EDID configuration from
the receiver's OSD (see EDID Mode,
page 76).
Chapter 14. CLI Commands
Description
Description
Description
Description
225