Table of Contents
Advertisement
RCM KVM over IP Transmitter User Manual
RCMDVI00BT / RCMDVI40BT / RCMDVI50T
Point-to-Point Installation
Setting up the RCMDVI00BT / RCMDVI40BT / RCMDVI50T system in a
point-to-point configuration is simply a matter of plugging in the cables. Since
this is a transmitter-receiver setup, we will demonstrate using RCMDVI40BT-
KE6910R.
Note: 1. In a point-to-point configuration, no administrator setup is necessary.
2. It is highly recommended to mount RCMDVI00BT / RCMDVI40BT
/ RCMDVI50T on a rack or wall and avoid stacked setup to ensure
proper ventilation.
Make sure that all the equipment is powered off. Refer to the installation
diagrams on the next two pages and do the following:
1. Use a grounding wire to connect the unit's grounding terminal to a suitable
grounded object.
2. Plug the mouse, keyboard, DVI monitor(s), and serial devices into the
unit's console ports.
3. Connect the KVM cable (DVI-D, USB, audio) and the DVI-D cable
(RCMDVI40AT only) provided into the KVM ports on the front of the
unit.
4. Connect the other end of the KVM cable (DVI-D, USB, audio) and the
DVI-D cable (RCMDVI40BT only) into the keyboard, video, mouse,
speaker and microphone ports on the PC / workstation.
5. For control of serial devices, connect the RS-232 port on the front of the
transmitter to a serial port on the computer.
6. Connect the KVM over IP Access Control Box (2XRT-0015G) for access
control.
7. Connect the stack light or temperature sensor for safety purposes.
8. Plug the mouse, keyboard, DVI monitor(s), and serial devices into the
console ports of the receiver (KE6910R is used as the example here)
9. Connect a Cat 5e/6 cable to the transmitter's LAN port.
10. Connect the other end of the Cat 5e/6 cable to the receiver's LAN port.
38
1
.
Advertisement
Table of Contents
