Rcmdvi40At Rear View - ATEN RCMDVI00BT User Manual

RCMDVI40AT Rear View

1 2
6 7
No. Component
1 grounding terminal
2 reset button
3 audio ports
4 LAN port
5 remote port
6 power jack
3
8 9 10
The wire used to ground the unit connects here.
This reset button must be pushed with a thin object,
such as the end of a paper clip.

Press and release to reboot the device.

Power off, hold reset then power on the device
while pressing reset to recover from a firmware
upgrade failure.

Press and hold it in for more than three seconds
resets the unit back to its factory default
settings*.
Note: The Reset to Factory Default function resets everything
but the login information (username/password) to the factory
default settings. To reset the login information, refer to Reset
All Information on page 266.
These mini stereo ports can connect to speakers
(green) and a microphone (pink).
The cable that connects the unit to the LAN plugs in
here.
Connects an Ethernet cable to allow access to the web
interface of the unit or for CCVSR recording.
The cable from the DC power adapter connects here.
Chapter 1. Introduction
4 5
11
Description
12
15