Table of Contents
Advertisement
RCM KVM over IP Transmitter User Manual
2. Click Add and select the media source.
Depending on your selection, additional dialog boxes appear enabling you
to select the drive, file, folder, or removable disk you desire. See Virtual
Media Support, page 279 for details about mounting these media types.
3. To add additional media sources, click Add, and select the source.
Up to three virtual media choices can be added. To rearrange the selection
order, highlight the device you want to move, then click the Up or Down
Arrow button to promote or demote it in the list.
4. Read refers to the redirected device being able to send data to the remote
server. Write refers to the redirected device being able to have data from
the remote server written to it. The default is Read. If you want the
redirected device to be writable, check the Enable Write checkbox:
Note: 1. If a redirected device cannot be written to, or if a user does not
have write permissions, it appears in gray and cannot be selected.
2. See Virtual Media Support, page 279, for a list of supported
virtual media types.
5. To remove an entry from the list, highlight it and click Remove.
6. After you have made your media source selections, click Mount. The
dialog box closes. The virtual media devices that you have selected are
redirected to the remote system, where they show up as drives, files and
folders on the remote system's file system.
202
Advertisement
Table of Contents
