Table of Contents
Advertisement
Chapter 7. System Status
Intelligent Dual Video Output Management
For RCMDVI40AT / RCMDVI40BT, the Intelligent Dual Video Output
Management feature allows the separation of its 2 video outputs (DVI:1 and
DVI:2), to be managed as two separate Virtual Transmitters. These separated
outputs can be accessed from different receivers. Receivers can switch between
and connect to both Virtual Transmitters independently with the Access Type
determining which receiver has control (see page 127).
To use this setup, install the KE devices as shown below and create two Virtual
Transmitters, selecting DVI:1 and DVI:2 as the KVM source for each Virtual
Transmitter.
For RCMDVI00AT / RCMDVI00BT / RCMDVI50T, you can select between
DVI:1 or DVI:2, but you will always be getting video output from DVI:1.
When connecting to either of the two Virtual Transmitters in the setup shown
above, the mouse cursor may reside on the main or extended dual display
screen, out of view. Therefore even if you have control of the mouse it may not
be visible. To bring the mouse cursor into view on either of the dual display
screens, first, enable Boundless Switching (see Boundless Switching,
page 138) and then use the hotkey F8+F9.
125
Advertisement
Table of Contents
