Table of Contents
Advertisement
RCM KVM over IP Transmitter User Manual
Device/Profile Commands
When typing a device or profile into a command string, you can enter the name
by: IP address (device only), ID or @ with the List number for the device/
profile in the command line interface.
Note: To find out about the List number for a device/profile, execute a List
command (page 232).
Telnet
The RCM/KE Series can be operated and configured via a remote terminal
session using Telnet. This is a useful means for configuring devices when they
are first setup and connected to the network.
To log into the RCM/KE Series device by means of a Telnet session, do the
following:
1. On your computer, open a terminal (command line) session.
2. At the prompt, key in the RCM/KE device's IP address with port 9130 in
the following way:
telnet [IP address] [port]
3. Press Enter. The login screen appears. At the login prompt, provide the
Password.
Verification
After sending a command, a verification message appears at the end of the
command line. Use the echo command to identify a command by number:
Command OK - the command is correct and performed successfully
Command incorrect - the command has the wrong format and/or values.
Echo Command - at the end of a command string, type: e1234 – where
1234 can be any number. The verification message returns with the echo
number.
216
Advertisement
Table of Contents
