Table of Contents
Advertisement
RCM KVM over IP Transmitter User Manual
Item
Video Settings
IP Settings
Password
Protection
RS232 Settings
114
These refer to the transmitter's video settings:
Video Type: Select the DVI video connector being used by the
display: Digital (DVI-D) or Digital (DVI-I).
Color Depth: Select the number of bits to use for the color depth:
24, 16, or 8. This is the number of bits used to describe the color of
a single pixel. A bit depth determines the number of colors that can
be displayed at one time.
Bandwidth Limit: Select the maximum bandwidth that the
Transmitter can use to transmit video over the network. A lower
bandwidth transmits lower quality video; a higher bandwidth sends
higher quality video but this can affect network speed.
Video Quality: Select the video quality to use, with the highest to
lowest quality being Lossless > Light Compression > Medium
Compression > Heavy Compression > Maximum Compression.
Background Refresh: Sets how often the transmitter refreshes
the background image on the connected display. Options are to
refresh every 256,128, 64, 32,16, or 0 frames.
For dynamic IP address assignment, select the DHCP radio button.
To specify a fixed IP Address, Subnet Mask, and Default Gateway
select the Manual radio button and fill in the fields with values
appropriate for your network.
For information to configure the network settings locally on the
device, see Network Configuration, page 46.
Select Enable to require a password to access the transmitter's
OSD configuration screens (see page 59).
Enter a Password, and confirm the password in the Confirm box.
Configure the serial device settings for the transmitter. The default
settings are:
Baud Rate: 9600
Parity: None
Data Bits: 8 bits
Stop bits: 1 bit
Flow Control: None
Description
Advertisement
Table of Contents
