Rcmdvi00At / Rcmdvi40At Point-To-Point Installation - ATEN RCMDVI00BT User Manual

RCMDVI00AT / RCMDVI40AT
Point-to-Point Installation
Setting up the RCMDVI00AT / RCMDVI40AT system in a point-to-point
configuration is simply a matter of plugging in the cables. Since this is a
transmitter-receiver setup, we will demonstrate using RCMDVI40AT-
KE6940AR.
Note: 1. In a point-to-point configuration, no administrator setup is necessary.
2. It is highly recommended to mount RCMDVI00AT / RCMDVI40AT
on a rack or wall and avoid stacked setup to ensure proper ventilation.
Make sure that all the equipment is powered off. Refer to the installation
diagrams on the next two pages and do the following:
1. Use a grounding wire to connect the unit's grounding terminal to a suitable
grounded object.
2. Plug the mouse, keyboard, DVI monitor(s), and serial devices into the
unit's console ports.
3. Connect the KVM cable (DVI-D, USB, audio) and the DVI-D cable
(RCMDVI40AT only) provided into the KVM ports on the front of the
unit.
4. Connect the other end of the KVM cable (DVI-D, USB, audio) and the
DVI-D cable (RCMDVI40AT only) into the keyboard, video, mouse,
speaker and microphone ports on the PC / workstation.
5. For control of serial devices, connect the RS-232 port on the front of the
transmitter to a serial port on the computer.
6. Plug the mouse, keyboard, DVI monitor(s), and serial devices into the
console ports of the receiver (KE6940AR is used as the example here)
7. Connect a Cat 5e/6 cable to the transmitter's LAN port.
8. Connect the other end of the Cat 5e/6 cable to the receiver's LAN port.
9. To allow remote access to the web interface of the transmitter or for
CCVSR recording, use an Ethernet cable to connect its remote port to a
network.
Chapter 2. Hardware Setup
1
.
31