Table of Contents
Advertisement
No.
Component
9
function switch
10
remote port
11
LAN port
12
SFP slot
13
DVI-I out
Use this switch to set the unit's mode to:
Auto: Shared (simultaneous) KVM control of the PC
/ workstation at the transmitter and receiver
console.*
RS-232 Config: The device is ready to be
configured via serial commands through the RS-232
port. When connected to a KVM over IP Access
Control Box (2XRT-0015G), users can enable /
disable control privileges of the connected
receivers.
Local: Only the local transmitter has KVM control of
the PC / workstation. The receiver's KVM access to
the PC / workstation is locked.
Note: In Auto mode, RS-232 and audio functions will
work on the receiver but not on the transmitter.
Connects an Ethernet cable to allow access to the web
interface of the unit or for CCVSR recording.
The cable that connects the unit to the LAN plugs in
here.
The Gigabit Ethernet (GbE) optical fiber cable that
connects the unit to the LAN plugs in here.
The cable from the local DVI monitor plugs in here.
Chapter 1. Introduction
Description
25
Advertisement
Table of Contents
