Table of Contents
Advertisement
Item
IP Settings
For dynamic IP address assignment, select the DHCP radio button.
To specify a fixed IP Address, Subnet Mask, and Default Gateway
select the Manual radio button and fill in the fields with values
appropriate for your network.
For information to configure the network settings locally on the
device, see Network Configuration, page 46.
Password
Select Enable to require a password to access the receiver's OSD
Protection
configuration screen (see page 57).
Enter a Password, and confirm the password in the Confirm box.
USB Mode
Select the type of USB device you will connect to the USB ports:
Virtual Media: Select this option only if you are plugging a USB
disk drive (including USB HDD/optical disk) into the USB ports.
This will give you the highest data transfer speeds but will not allow
other USB devices to work when plugged into the USB ports. When
receivers connected to the same transmitter mount or unmount
USB disk drives, the keyboard and mouse operations will
experience a brief delay. transmitters can support up to 12 virtual
media connections at the same time (keyboard/mouse included).
vUSB (Generic USB device): Use this option to plug USB
peripherals into the USB ports. In this mode, RCMDVI00AT /
RCMDVI40AT / RCMDVI00BT / RCMDVI40BT / RCMDVI50T
support up to 5 USB connections (keyboard/mouse excluded).
Encryption: Check this box to encrypt USB disk drives plugged
into the USB ports.
Replace Device
Click Replace Device in the top left corner to replace an old
receiver with a new one.* All settings are copied from the old
receiver to the new one. Before using this feature, connect the new
receiver to the network. After clicking Replace Device, use the
drop-down menu to select the new receiver where the settings will
be applied.
Note:
Save
Click Save to save changes to the properties.
Cancel
Click Cancel to exit without saving.
1. This option only appears when a receiver is offline.
2. This feature can be used for both receivers and
transmitters. Replacement should be carried out on a
similar model.
Chapter 7. System Status
Description
133
Advertisement
Table of Contents
