Installing The I/O Fan; Removing The System Board Fan - HP Vizualize,Visualize b2000 Supplementary Manual

Installing the I/O Fan

Perform the following steps to install the I/O fan:
1. Remove the replacement I/O fan assembly from the ESD protective packaging and
inspect for the correct part match to your order.
2. Install the speaker in the replacement I/O fan assembly. See "Installing the Speaker" on
page 81.
3. Align the housing fan bracket to the chassis support strut and the two locator tabs.
Hold the fan and speaker cable to the card guide edge of the bracket.
4. Swing the housing bracket into place while holding the retainer tab upward.
5. Plug in the speaker cable and the fan power cable to the system board.
6. Install the air divider. See Figure 2-63.
7. Install the I/O card(s) and the PCI retainer clip. See "Installing I/O Cards" on page 28
8. Replace the left side panel. See "Left Side Panel" on page 16.
9. Follow the instructions in Chapter 3, "Wrapping Up," on page 85 to complete this
procedure.

Removing the System Board Fan

Perform the following steps to remove the system fan:
1. Remove the left side panel. See "Left Side Panel" on page 16.
2. Remove the four plastic pop rivets to release the system fan from the rear panel. Press
firmly with a flat blade screw driver to relieve the rivet from the chassis wall. See
Figure 2-67.
Figure 2-67. System Fan Rivets
3. Disconnect the fan power cable from the system board.
Chapter 2
Parts Replacement Procedures
Fans (I/O and System Board Fan)
Fan Power Cable
Tip of flat blade screw driver
75