Hard Disk Drive; Installing A Hard Disk Drive - HP Vizualize,Visualize b2000 Supplementary Manual

Hard Disk Drive

This section explains how to remove and replace the hard disk drive.

Installing a Hard Disk Drive

This procedure explains how to install your hard disk drive in the slot that has been
preassigned to SCSI ID 5. On internal hard disk drives, the slot determines the
addressing. There are no cables required when installing a hard disk drive. Note that to
install the hard disk drive, your workstation must be turned off.
WARNING Turn the workstation off and unplug the power cord before
installing or removing hard disk drives. Reference "Safely Powering
Down the B2000 Workstation" on page 12.
CAUTION
To prevent damage to the B2000 workstation, observe all of the ESD
precautions as described in the "Electrostatic Discharge (ESD) Precautions"
on page 9.
NOTE If you are installing a hard disk drive
file system on it. See "Configuring and Hard Disk Drive as A File System" in
your Owner's Guide. This should be done after you have installed the hard
disk drive.
To mount a hard disk drive and create a file system on it use the procedure
provided "Adding a Hard Disk Drive as a File System Using SAM" found in
this section. See "Configuring a Hard Disk Drive as a File System" on page
52.
1. Remove the side panel of your workstation using the instructions found in the section
"Opening the Side Panel." As you face the workstation system board, the hard disk
drives are on the right side. The hard disk drive plugged into the lower SCSI connector
(ID 5) is the one discussed in this section. See Figure 2-36.
1. This statement exclusively applies to the disk drive with SCSI ID 5 in the B2000 workstation.
Chapter 2
Parts Replacement Procedures
1
, you will need to mount it and create a
Hard Disk Drive
45